**Structural Design of Steelwork to EN 1993 and EN 1994, Third Edition.**

This book conforms to the latest recommendations for the design of steel and composite steel–concrete structures as described in Eurocode 3: Design of steel structures and Eurocode 4: Design of composite steel–concrete structures. References to relevant clauses of the Codes are given where appropriate. Note that for normal steelwork design, including joints, three sections of EN 1993 are required:

• Part 1–1 General rules and rules for buildings

• Part 1–5 Plated structural elements

• Part 1–8 Design of joints

Additionally if design for cold formed sections is carried out from first principles then Part 1–3 Cold formed thin gauge members and sheeting is also required. Whilst it has not been assumed that the reader has a knowledge of structural design, a knowledge of structural mechanics and stress analysis is a prerequisite. However, as noted below certain specialist areas of analysis have been covered in detail since the Codes do not provide the requisite information. Thus the book contains detailed explanations of the principles underlying steelwork design and provides appropriate references and suggestions for further reading.

The text should prove useful to students reading for engineering degrees at University, especially for design projects. It will also aid designers who require an introduction to the new Eurocodes.

For those familiar with current practice, the major changes are:

(1) There is need to refer to more than one part of the various codes with calculations generally becoming more extensive and complex.

(2) Steelwork design stresses are increased as the gamma values on steel are taken as 1,0, and the strength of high yield reinforcement is 500 MPa albeit with a gamma factor of 1,15.

(3) A deeper understanding of buckling phenomena is required as the Codes do not supply the relevant formulae.

(4) Flexure and axial force interaction equations are more complex, thus increasing the calculations for column design.

(5) The checking of webs for in-plane forces is more complex.

(6) Although tension field theory (or its equivalent) may be used for plate girders, the calculations are simplified compared to earlier versions of the Code.

(7) Joints are required to be designed for both strength and stiffness.

(8) More comprehensive information is given on thin-walled sections.

You May Also Like:

- Structural Analysis Fourth Edition, SI by Aslam Kassimali pdf download
- Download Structural Behavior of Asphalt Pavements by Lijun Sun free PDF
- Download Structural Analysis in Theory and Practice by Alan Williams free PDF
- Precast Concrete Structures Second Edition by Kim S.Elliott pdf download
- Steel Design Fifth Edition by William T. Segui free pdf download
- Composite Construction in Steel and Concrete VII Edited By Mark Bradford, Brian Uy pdf download

**Download Structural Design of Steelwork to EN 1993 and EN 1994, Third Edition in free pdf format.**