# Connection Star Delta Starter PDF

## Content of Connection Star Delta Starter

Chapter 1: INTRODUCTION
1.1 Introduction
1.2 Problem Statement
1.3 Objectives
1.4 Methodology
1.5 Thesis Outline
Chapter 2: LITERATURE REVIEWS
2.1 Introduction
2.2 Star-Delta connection
2.2.1 Star or Y-connected system
2.2.2 Delta or Mesh Connected Circuit
2.3 Theory of Star Delta Starter Method of Starting of Induction Motor
2.4 Working Principle of Induction Motor & Star-Delta Starter
2.5 Necessity of star delta starter
Chapter- 3 DESIGN METHODOLOGY
3.1 Introduction
3.2 Block diagram of star-delta starter
3.3 Flowchart
Chapter 4: HARDWARE DESCRIPTION
4.1 Introduction
4.2 Hardware parts
4.2.1 Magnetic conductor
4.2.3 Timer Relay
4.2.4 START and STOP push buttons switch
4.2.5 Cable
4.2.6 Interlock switches
4.3 Circuit diagram
4.4 Operating principle
Chapter-5 RESULT AND COST ANALYSIS
5.1 Introduction
5.2 Results
5.3 Three phase motor rating for star delta starter
5.4 Cost sheet
5.5 Cost comparison

## Connection Star Delta Starter

The star delta starter of induction motor is designed to reduce high starting current and torque. The star delta starter is designed by three magnetic contactors, an overload relay, timer relay and circuit breaker. For Starter, a motor must be connected in delta mode position during a normal run. When induction motor is start in direct online.

The motor winding flows a large amount of current. The starting high current can be reached in 8-10 times of the rated. So, there is need to control high starting current before starting the motor Therefore, in a star connected system line current is equal to phase current but line voltage is equal to the root three times of phase voltage. For these reasons at first motor is connected to the star system and it reduce the high starting current. In delta connection, line voltage is equal to phase voltage and line current is equal to √3 times phase current. In run mode the motor connects in delta system so that the full voltage applied to the motor. The Starter is made by three magnetic contactors, timer relay, and a thermal overload relay or circuit breaker.